3 Minute Read
| Introduction
Once a Named Schedule is created, it becomes available to apply to all zones of all buildings that fall under an organization.
| Applying Named Schedules
The Named schedule can be applied to zones of a building from two different places:
Applying from Heatmap Zone level Visualization Screen:
Navigate to the Heatmap by selecting the site or building in your scope.
The following Heatmap screen is displayed:
- Click a Zone to visualize its 'predefined visualizations' screen.
- Scroll to locate the schedule section of the screen:
- Click the 'Named Schedule' option:
- Click the 'Select Named Schedule' dropdown:
A list with all named schedules created for the organization is displayed.
- Select the named schedule you wish to apply for the particular zone.
A window to confirm the selection will appear. Confirm your selection.
- Click Set.
A confirmation window will display as follows:
- Click Confirm to apply.
The named schedule is applied, and the zone will start using the named schedule for its HVAC needs.
Applying from Zones Screen:
Begin from the zone screen in facilisight
- Select the zone in scope.
The zone screen will display relevant zone details:
- Scroll to locate the schedule section:
You can see the current named schedule in effect.
You can use the drop down to select and apply another named schedule as shown below:
Note: Once the named schedule is applied, it cannot be edited from normal schedule pages like the zone or the building schedule, but rather can only can be edited from the named schedule section in the internal portal.
| Nuances and Criterion Verified While Applying a Named Schedule
The system checks for a few nuances and criterion when one is trying to apply a named schedule to a zone. Only if all criterion are met will the system let the user apply the named schedule.
Following are the criterion that are verified while applying a Named Schedule.
- The desired temperatures set for named schedule must be within the building's desired temperature limits.
- The Schedule duration set for named schedule, must be within the Building schedule duration limits.
- The deadbands(cooling and heating) for the named schedule, must be the same as the deadbands used for the module.
Even if only one of the criterion is not met, a warning window is displayed as shown below:
Desired Temperature Warning
In this case the named schedule applied is outside the desired temperature limits of the building, which results in the system preventing you from applying the named schedule.
You must go back and edit the named schedule to perform within the set building parameters for it to apply.
Deadband Warning
In this case, the cooling deadband for the named schedule not the same as that of the module; thus, the system does not allow you to apply the named schedule.
You must go back and edit the named schedule to perform within the set building parameters for it to apply.
Comments
0 comments
Please sign in to leave a comment.