Matt Blount
- Total activity 168
- Last activity
- Member since
- Following 0 users
- Followed by 2 users
- Votes 0
- Subscriptions 88
Articles
Recent activity by Matt Blount-
Bypass Damper Installation
Installation | Wiring Configuration You must configure the pressure sensor to meet the needs of the duct work. Below shows how to Set the dip switches on the pressure transducer. Take note of w...
-
Central Control Unit (CCU) Installation
The 75F Central Control Unit (CCU) is the local interface and access point for the entire 75F System. With the help of cloud computing and wireless sensors, the CCU optimizes the efficiency of exis...
-
Smart Node Zone Installation
A Remote Temperature and Humidity (RTH) sensor paired with a Smart Node results in a clean aesthetic in your space while minimizing installation times. The RTH provides highly accurate temperature ...
-
Smart Stat Installation
| PRECAUTIONS Take all precautions normally taken when installing a thermostat (e.g. not in direct sunlight, not on an exterior wall, not near heat producing equipment) Disconnect power before i...
-
Importance of the CCU
Every 75F building implementation must have at least one Central Control Unit. The CCU is critical to the value of data aggregation and cloud computing that 75F provides. - Green Antenna - 900Mhz...
-
Lighting Control Module (LCM) - Smart Node Wiring Schematic
-
Scheduling System Vacation - CCU
This video shows how to schedule a system vacation so that your system will go into setback during a company holiday rather than following the regular weekly schedule. See the screenshot below ...
-
Energy Meter - Installation
For revenue grade energy metering 75F uses Modbus communication between a Schneider 3150 energy meter and a 75F Smart Node. Please read and understand the Schneider 3150 installation manual before ...
-
Humidifier or Dehumidifier Control with a CCU
|Wiring Follow the wiring schematic below. To make the Auxiliary 1 (Relay 7) a dry contact you must remove the jumper at J21 on the CM board. |Configuration In Setup > Settings > System Equipm...
-
Power Consumption Requirements
Max power consumption by product. Smart Node - 3.5VA CCU - 19.5VA Smart Stat - <1VA