Enabling and Disabling Temperature Averaging in HelioNode

| Overview

The 75F HelioNode has an onboard temperature sensor and includes a one-wire protocol slot that allows additional temperature sensors to be connected. Using the daisy-chain wiring, multiple temperature sensors can be installed on the same bus.

Because of this capability, the HelioNode provides a user interface (UI) that allows users to configure which temperature value should be displayed and communicated to the master controller.

The device can be configured in two ways:

• It can display and communicate the average temperature of all the sensors connected on the bus, or

• It can display and communicate only the temperature measured by the onboard sensor.

| Enabling and Disabling Averaging

To enable or disable the temperature averaging for the HelioNode

From the Installer option screen

• Navigate to the Average Onboard Sensors option.

• Press the right button on the HelioNode to access the Option. 

• Use the up or down arrow to set it to a ON/OFF.

• Press the Set button to confirm.