75F System- Usage Globalization

3 Minute Read

| Overview

Globalization is the concept of bringing in different units for a particular parameter into the system, and also allowing the installers or facility managers to set the preferred unit for a particular parameter which is measured and displayed by the 75F system. This is implemented in the portals of the 75F system to provide multi-unit support for the parameters listed below. 

| References

To best understand how to utilize the globalization integrated within your 75F products, refer to the 'User Preference Management' section in User Management - Internal

With the above options for parameter units, preferences based on the country/organization/user can be precisely catered to through 75F products. Once the unit preferences for the parameters are set, the 75F system measures and displays the parameter with the preferred units at all applicable places within the system.

Note: The units preferences set from the portals takes effect in only the portals and does not cascade to the CCU, and the unit preference set in the CCU takes effect only in the CCU, without cascading to the portals. 

Once unit preference for temperature is set to Celsius in the portals, the same takes effect in the heatmap screens, visualizations and user intent under zone settings sections as below.

| Heatmap 

| Visualizations

| User Intent

Note: Just like the Fahrenheit mode the user intent for the desired temperatures are incremented or decremented in 0.5 ℃

For the conversion and rounding off mechanized refer to Fahrenheit & Celsius- Conversion Rounding off Strategy